Technology selection · 7 min read

Digital or analog: what actually changes on site

Capacity, coverage at the edge, battery life, and why the migration is usually gradual rather than total.

On this page

Digital doubles capacity in the same channel

DMR digital radio uses two-slot TDMA inside a 12.5 kHz channel. Two conversations share the channel that analog uses for one. For a site that is running out of channels, that is the single most useful difference — the manufacturer's own figure for the CP100d is twice the voice capacity in a 12.5 kHz licensed channel.

It also means a digital fleet can often be licensed on the assignment you already hold, instead of applying for more spectrum.

How each one fails at the edge of coverage

Analog degrades gracefully: as you walk out of range, audio fills with hiss and you can still catch words. Digital holds full clarity until the signal drops below a threshold, then it goes away quickly.

Neither behaviour is better in the abstract. Analog gives a longer usable fringe; digital gives cleaner audio inside the coverage area. For a warehouse where people work at the far end of a rack run, that difference is worth testing on site rather than arguing about on paper.

Practical test

Walk the actual site with one radio of each type before committing a fleet. Two identical-looking buildings can behave completely differently because of racking, cladding and mezzanine floors.

Battery, audio and noise

Digital transmission is not continuous, so talk time improves: the CP100d is quoted at up to 35% longer talk time in digital than analog. For a three-shift operation that is the difference between one battery per shift and two.

Noise handling is the other visible gain. Features like SINC+ noise cancellation on the R2 and adaptive dual-microphone suppression on the R7 are digital-domain processing — they simply do not exist in an analog set.

When analog is still the right answer

If your fleet is small, the site is simple, and everyone is already on analog, replacing working hardware has no payback. Add dual-mode radios where they are needed and keep the rest.

Analog is also easier to share with subcontractors and temporary staff who bring their own compliant radios, because there is no codeplug to match and no firmware conversation to have.

A migration path that does not stop the site

The pattern that works: buy dual-mode radios for the people who need new hardware, program one zone in analog for the old fleet and one in digital for the new, then move teams across as their turn comes.

Because every radio ships programmed to your channel plan, that transition is a firmware-and-codeplug exercise rather than a hardware replacement.